- Xerox 3535 printer/copier user guide
Table Of Contents
- Electrical Safety
- Laser Safety
- Maintenance Safety
- Operational Safety
- Ozone Safety
- Radio Frequency Emissions
- Safety Extra Low Voltage Approval
- Certifications in Europe
- It’s Illegal in the USA
- It’s Illegal in Canada
- Environmental Notices for the USA
- Environmental Notices for Canada
- Product Recycling and Disposal
- Symbols
- Getting to Know Your Copier
- Quick Start Guide to Copying
- Copier Features
- Duplex Automatic Document Feeder (DADF)
- Job Status
- Machine Status
- Overview
- Overview
- How to Scan
- Creating Job Templates
- Scanning Features
- How to Pause or Cancel a Scanning Job
- Scanning in Batches
- Managing Scanned Documents
- Configuring the Client for Scanning
- Overview
- System Settings
- Setting and Changing the Administrator Password
- Entering and Exiting the System Settings Mode
- Changing Settings in System Settings Mode
- Common Settings
- Copy Mode Settings
- Network Settings
- Scan Mode Settings
- Auditron Administration
- Loading Paper
- Machine Specifications
- Finisher (Optional Accessory)
- Ordering Consumables
- Cleaning the DADF and Document Glass
- Cleaning the ROS Window
- Changing Toner Cartridges
- Changing Staple Cartridges
- Changing the Fuser
- Changing the Waste Toner Container
- Changing Drum Cartridges
- Paper Jam Clearance
- Document Jams
- Stapler Faults
- Resolving Hardware Problems
- Resolving Programming Problems
- Resolving Processor Problems
- Resolving Output Problems using Basic Copying, Added Features, and Image Quality Tabs
- Calling for Service
- Fault Codes
1–41
Xerox DocuColor 3535 Printer/Copier
Border Erase
The Border Erase feature enables you to eliminate unwanted
marks near the edges of the original from the output copy. The
range for Border Erase is 0 through 50mm (0.0 through 2.0
inches) in 1mm (0.1 inch) increments.
Border Erase options can be used individually or combined
together:
Top & Bottom For Normal the default is 2mm (0.1 inch). For Variable Erase the
default is 5mm (0.2 inch).
Left & Right For Normal the default is 2mm (0.1 inch). For Variable Erase the
default is 5mm (0.2 inch).
Center The default is 0mm (0 inches).
The selected settings are applied to both sides of 2-sided copies.
When the image is reduced or enlarged, the selected percentage
will be applied to the Border Erase.
When making copies the copier adds a margin of 2mm (0.1 inch)
to all sides. This cannot be eliminated.