- Hewlett-Packard Carrier MultiPath Switch Product Guide
Table Of Contents
- Table of Contents
- About this Guide
- Chapter 1: Overview
- Chapter 2: Hardware Components
- Chapter 3: Installation
- Installation
- Connection
- Connect Power - CMS (14 slot), DC only)
- Connect Power - CMS960 (8 slot) and CMS240 (2 slot), DC only
- Install Power Cord Strain Relief (AC only)
- Power up the System (for AC unit)
- Prevent Electrostatic Discharge Damage
- Assign IP Address
- Install Software Upgrade via CMS Software Update Utility
- Chapter 4: Getting Started with Command Line Interface (CLI)
- Chapter 5: Working with SNMP
- Chapter 6: Call Detail Recording
- Chapter 7: System Alarms
- Chapter 8: Diagnostics/Maintenance
- Appendix A: Getting Acquainted with Tenor CMS in the VoIP Network
- Appendix B: Specifications/Approvals
- GLOSSARY
- INDEX
- WARRANTY
P/N 480-0005-00-15 4-15
Chapter 4: Getting Started with Command Line Interface
config-IPDialPlan-1# set mytechprefix [5] 789. Assigns the 5th element of MyTechPrefix (part of
IPDialPlan) to 789.
Remove an attribute as follows:
config-DialPlan-1# set internationalprefix [2]. Erases 2nd element of InternationalPrefix (part of
Dial Plan option) and sets it to the default value.
config-IPDialPlan-1# set mytechprefix [5]. Assigns the 5th element of MyTechPrefix (part of IPDi-
alPlan) to the default entry.
To associate a selected CLI option to another, type set followed by the name of the option to which you want
to attach. A “..” indicates a range of values.
Example
config-ChannelGroup-1# set SignalingGroupAttached ISDNSignalingGroup-1 (or set sga isdn-1).
Associates ChannelGroup -1 to ISDN SignalingGroup-1.
To detach a selected CLI option from another, type set followed only by the name of the option you want to
detach.
Example
config-ChannelGroup-1# set SignalingGroupAttached (or set sga). Detaches ChannelGroup -1 to
ISDN SignalingGroup-1.