- Hewlett-Packard Carrier MultiPath Switch Product Guide
Table Of Contents
- Table of Contents
- About this Guide
- Chapter 1: Overview
- Chapter 2: Hardware Components
- Chapter 3: Installation
- Installation
- Connection
- Connect Power - CMS (14 slot), DC only)
- Connect Power - CMS960 (8 slot) and CMS240 (2 slot), DC only
- Install Power Cord Strain Relief (AC only)
- Power up the System (for AC unit)
- Prevent Electrostatic Discharge Damage
- Assign IP Address
- Install Software Upgrade via CMS Software Update Utility
- Chapter 4: Getting Started with Command Line Interface (CLI)
- Chapter 5: Working with SNMP
- Chapter 6: Call Detail Recording
- Chapter 7: System Alarms
- Chapter 8: Diagnostics/Maintenance
- Appendix A: Getting Acquainted with Tenor CMS in the VoIP Network
- Appendix B: Specifications/Approvals
- GLOSSARY
- INDEX
- WARRANTY
7-6 P/N 480-0005-00-15
Chapter 7: System Alarms
Major File Missing in the File Server This alarm will be reported to the system when a partic-
ular voice prompt file is not found in the IVR Prompt
Server.
This alarm applies only to the system with enabled IVR
functionality.
Major Switch to other RADIUS server Appears when the current RADIUS server stops
responding after three consecutive calls end in timeouts
and another RADIUS server is configured The Tenor
will then switch to the next RADIUS server.
Minor Call Event(s) Lost A call has failed.
Minor Missing or Incorrect Profile The configuration profile has caused a problem.
Minor Minor Software Error A software error has occurred but will not affect the
operation of the complete system.
Minor No response to seizure There has been a problem with the T1 line.
Minor Remote end did not back off in a glare
situation
An incoming and outgoing call went through at the same
time, and the remote end call did not back off.
Minor Chassis resource constrained A shared resource in the unit loads the system.
Minor Hardware component failed A hardware component has failed. Check all compo-
nents, hardware connections, etc.
Minor Log RADIUS server error Displayed when the RADIUS server fails to send
required data or the data sent by the RADIUS server has
improper values. Incorrect information may contain the
following:
RADIUS Server: Credit amount (-1)
RADIUS Server: Credit minus amount
RADIUS Server: Not supported currency
RADIUS Server: Credit time (-1)
RADIUS Server: Credit time < 6 sec
RADIUS Server: Invalid error code
Informational Gatekeeper status Reports the status of the Gatekeeper.
Informational Miscellaneous information Miscellaneous information about the unit is reported.
The contents of this alarm will vary.
Informational Info Software Error Indicates information about miscellaneous software
error. This does not affect system operation.
Informational Glare occurred An incoming and outgoing call went through at the same
time, and the remote end call did not back off, but the
situation was corrected.
Severity
(appears as
part of severity
field)
Alarm Description
(text appears in desc field)
Definition