- Hewlett-Packard Carrier MultiPath Switch Product Guide
Table Of Contents
- Table of Contents
- About this Guide
- Chapter 1: Overview
- Chapter 2: Hardware Components
- Chapter 3: Installation
- Installation
- Connection
- Connect Power - CMS (14 slot), DC only)
- Connect Power - CMS960 (8 slot) and CMS240 (2 slot), DC only
- Install Power Cord Strain Relief (AC only)
- Power up the System (for AC unit)
- Prevent Electrostatic Discharge Damage
- Assign IP Address
- Install Software Upgrade via CMS Software Update Utility
- Chapter 4: Getting Started with Command Line Interface (CLI)
- Chapter 5: Working with SNMP
- Chapter 6: Call Detail Recording
- Chapter 7: System Alarms
- Chapter 8: Diagnostics/Maintenance
- Appendix A: Getting Acquainted with Tenor CMS in the VoIP Network
- Appendix B: Specifications/Approvals
- GLOSSARY
- INDEX
- WARRANTY
P/N 480-0005-00-15 2-13
Chapter 2: Hardware Components
Front view (with DC power)
Figure 2-11 Tenor CMS240 Front View - DC unit
• Card Slots. Two slots are available for WAN cards (T1/E1/DS1), DSP cards, and the CPU/System Con-
troller card.
• Power Supply. One DC Power Supply.
• Wrist Strap Ground Socket. Socket available in which to connect an ESD wrist strap for ESD protec-
tion.
D.C. Power Supply
Power Alarm
QUINTUM
TECHNOLOGIES, INC.
TM
TECHNOLOGIES, INC.
QUINTUM
TM
Hot Swap
DS1
Span
Status
4
8
3
7
26
15
10/100
Ethernet
DSP
Link
Alarm
CPU
1
1
2
2
Bank
TX/RX
St at us
PC I
TECHNOLOGIES, INC.
QUINTUM
TM
CPU
4
8
3
7
26
15
Alarm
CPU
2
St at us
PC I
Reset
10/100
Ethernet
Link TX/RX
Hot Swap
Power Supply
Card Slots
Wrist Strap
Ground
Socket