- Hewlett-Packard Carrier MultiPath Switch Product Guide

P/N 480-0005-00-15 3-16
Chapter 3: Installation
Install Power Cord Strain Relief (AC only)
NOTE: Instructions for using the Power Cord Strain Relief for DC power are included in the previous two
sections.
The Strain Relief Mount enables you to connect the power cord strain relief to the unit. A power cord strain
relief is a plastic device designed to avoid accidental power down of the Tenor CMS (i.e., if the power cord is
accidentally pulled, the strain relief will relieve pressure put on the cord.)
Install the strain relief as follows:
1. Loop the strain relief’s long plastic piece around the power cord and insert the end of the plastic rivet
through the hole at the opposite end (to create a “clamp”). See Figure 3-16.
Figure 3-16 Loop the strain relief around the power cord
2. Push the rivet into the Strain Relief Mount at the rear of the unit. See Figure 3-17.
Figure 3-17 Insert clamp in Strain Relief Mount
Rivet
Loop long piece around cord.
Power cord
10/100
Ethernet
1 2 3 4
5 6 7 8
DS1
Link TX/RX Link TX/RX
CPU
2
4
8
3
7
26 15
TX/RX
1 2 3 4
Link
Config
1 2 3 4
Off
On
Console
10/100
Ethernet
1
0
Strain Relief Mount
AC Power Plug