- Hewlett-Packard Printer Owner's Manual

CAUSE: You are in Printer Select Mode 1 with zero

(0) timeout.

SOLUTION: Switch to Printer Select Mode 2 or

increase timeout, both via configuration mode.

NOTE:

Any select sequence will not be

recognized after 16 characters in Printer Select

Mode 1.

SYMPTOM: SOME SORT OF PRINTER SELECT CODE

PRINTS ON DOCUMENT.

CAUSE: Printer Select Code sent does not match

Printer Select Code configured in Print Master.

SOLUTION: Match the Printer Select Code sent

exactly with that configured in Print Master.

PROBLEM: CANNOT SELECT PRINTER DURING PRINT JOB

CAUSE: You are using Printer Select Mode 1 (printer

selection at beginning of printing only).

SOLUTION: Switch to Printer Select Mode 2 in

configuration (printer selection anytime while

printing).

PROBLEM: PRINT JOB SWITCHES PRINTERS IN THE MIDDLE

OF A PRINT JOB

CAUSE: Timeout period too short.

SOLUTION: Increase input inactivity timeout period via

configuration mode.

CAUSE: Port select sequence sent in the middle of the

document.

SOLUTION: Verify that Port Select Code is not

contained in the document. Do not activate the

hot key software while the print job is still being

sent from the computer