- Hewlett-Packard Printer Owner's Manual

54
CAUTION:
If Y is sent before changing the configuration device to
the new configuration (baud rate or parity), Print Master will not
receive the Y response. However, you will be locked out of Print
Master. If this occurs, recycle Print Master power. Print Master's
configuration will default back to the last saved configuration. You
must then re-enter configuration and re-save the configuration of the
configuration port.
If you answer Y (yes), the new configuration for that port will be stored
permanently in non-volatile memory, and Print Master will
subsequently power-up at that configuration.
If you answer N (no), the new configuration will be stored in RAM, and
on the next power-up, Print Master will revert to the previous
configuration.
NOTE:
The Y and N responses must be upper case. If a lower case
Y is entered, Print Master will interpret it as "no" and the changes you
have made will not be saved permanently in memory.
IMPORTANT:
Ports 9 and 10 on the model 710C must have matching
baud rates, word size, stop bits and parity. When you configure either
Port 9 or Port 10 individually, Print Master will automatically set the
other port to match. This does not affect XON/XOFF or Logical Name
settings, which are set individually.
Print Master will now return to the main configuration menu ( see
Section 7.2.1 ).