- Hewlett-Packard Printer Owner's Manual

62
3. Refer to the upper right hand corner of the screen for
Handshaking line status. RTS, CTS, DSR, and DTR
should all be HIGH. The DCD line is not looked at by
the terminal emulation program therefore its status can
be ignored. If these signals are not high at this point,
check to ensure the correct cable is connected.
4. Depress function key:
F1
. The
F1
key in TERM sends
the character sequence Control-T (14 Hex) followed by
the capital
C
character (43 Hex).
Make sure the keyboard of your computer or terminal is in the
CAPS LOCK position.
The main configuration menu will appear as shown in Section 7.3.1 .
From this point on, configuration of Print Master will be accomplished
by following the menus that will prompt you.
 !!

Print Master will respond to the receiving of Control-T and capital C
with an identification block and a menu of the configuration options
available, similar to the following:
Bay Technical Associates
Model 706D Print Master
Copyright 1989
Revision 3.00
Total Memory : 1024K Bytes
Status..............................1
Set Serial Port Configuration.......2
Change Port Logical Name............3
Set Port Assignment.................4
Set Input Inactivity Timeout........5
Program Printer Select Code.........6
Set Printer Select Mode.............7
Set Form Feed Mode..................8
Program Header Page Message.........9
Exit................................X
Enter Request: