- Hewlett-Packard Printer Owner's Manual

73
 !!
#
By responding to the Enter request: message at the end of the main
configuration menu with "9" (Program Header Page Message), you
may enable or disable this message and program its content.
Print Master will respond with:
Header Page Message is (OFF):
This print job is for:
Enter Header Page Message
(0 to 80 chrs, Ctrl C = Terminate):
Enter the new message, followed by Control-C . Note that the
message will print on paper exactly as it is placed on the CRT screen.
The message may appear on one line or several lines. If several
lines are desired, each line must be ended by Carriage Return and
Line Feed ( Control-J ). If no change in the message is desired, send
Control-C only, and the current message will be retained.
Print Master will respond with:
Print Header Page (R/Y/N)?............:
If you enter R (repeat), the entire sequence will be repeated, and you
may re-enter the Header Page Message. If you enter Y (yes), the
new Header Page Message will be stored permanently in non-volatile
memory and will print on all subsequent print jobs. If you enter N (no),
the Header Page Message will be disabled and will not print. The
new message, however, will be stored permanently in non-volatile
memory. Print Master will now return to the main configuration menu
(see Section 7.3.1 ).
 !!)
To exit the configuration mode, send capital
X
in response to the
prompt at the end of the main configuration menu, and Print Master
will return to the operating mode.