- Hewlett-Packard Printer Owner's Manual

88
(
When the computer connected to Port 10 of a 710 model with Option
19 accesses the configuration mode by sending Control-T followed
by capital
C
, Print Master will respond with an identification block and
main configuration menu similar to the following:
Bay Technical Associates
Model 710E Print Master with Option 19
Copyright 1986,1987,1988, 1989
Revision 3.00
Total Memory : 0512K Bytes
Status........................................1
Set Serial Port Configuration.................2
Change Port Logical Name......................3
Set Port Assignment...........................4
Set Input Inactivity Timeout..................5
Program Printer Select Code...................6
Set Printer Select Mode.......................7
Set Form Feed Mode............................8
Program Header Page Message...................9
Set Unit I.D. Number..........................A
Exit..........................................X
Enter Request:
All listings in the above menu except Set Unit I.D. Number are
configured as described in Section 7 of this manual. The Set Unit I.D.
Number selection is described in Appendix B.1.3 .
NOTE
: On the Model 710C, since the main configuration menu differs
slightly from the Models 710E and 710F, the Set Unit I.D. Number will
be listed as selection 9.
Menu selection is case sensitive. It is recommended that your
keyboard be in the CAPS LOCK position.