User's Manual

Settings
3Com®AirProtectPlannerUserGuide
103
¾ Power(mW):SelectapowerlevelfromthesupportedpowervaluesatwhichtheSensoroperatesforeach
selectedprotocol.Youmustkeepthedefaultvalues,whicharebasedonthemaximumtransmitpowerforthe
protocolaspermittedbytheregulatoryagenciesinthecountriesforwhichyouare
doingtheWLANplanning
(Example:FCCintheUnitedStates).RefertoAppendixD:GlossaryofTerms
formoredetailsonregulatory
domaincompliance.
¾ WaterfallCurve:Selectawaterfallcurvefromthedrop‐downlistofavailablewaterfallcurvesfortheselected
protocol.
¾ AdvancedParameters:Clicktosetadvance802.11nparameters
.Thisisavailableonlyifyouhaveselected
802.11nprotocol.
Click<Save>tosavethechanges.Alternately,click<Cancel>todiscardthechanges.