User's Manual

WorkingwiththeLocationsTreeandtheDevicesList
3Com®AirProtectPlannerUserGuide
18
Figure 15. Copying a location
2 Right‐clickthedestinationlocationfolderontowhichyouwanttopastethelocationselectedintheabovestep.Select
Paste.
Ifthelocationwhereyouarepastingthelocationfolderornodealreadyhasafolderornodewiththesamename,Planner
renamesthecopiedobjectsincrementallywithasuffix‘01’,‘02’,andsoon.
Note:IfanodebelongstoaCrossFloorlocationfolder,youcannotCut/CopyandPastethatnodeintoanotherfolder.Ifyouwanttocopy
thatnode,youmustcopytheentireCrossFloorlocationfolder.
4.1.8 MovingaLocation
Youcanmovelocationfoldersandnodeswithinalocationfolder.Thischangesthelocationhierarchyofthatfolderinthe
project.
Note:You cannotmovealocationifthelocationisnotunderthesameparentlocationfolder.
Usethefollowingstepstomovealocation:
1 Right‐clickalocationfolderornodefromtheLocationstree.
2 SelectMoveUporMoveDown.
3 Repeattheabovestepsuntilyoureachthedestinationfolderunderwhichyouwanttomovetheselectedlocation.
Figure 16. Moving a location
4.1.9 PlacingLocationsonaLocationFolderwithanattachedimage
Plannerenablesyoutoplacelocationsonalocationfolderthathasanattachedimage.Thishelpsyouidentifythephysical
positionofeachofthelocations.Thelocationsplacedontheattachedimageareindicatedbygreencoloredcircles.Usethe
followingstepstoplacelocationsontheattachedimage
andviewtheirdetails:
1 IntheLocationstree,selectalocationfolder.
2 ThebottomleftpanecalledLocationsshowsallthenodesandfoldersavailable undertheselectedlocationfolder.Drag
anddroptherequiredlocationsontheattachedimage,intherightpane.
3 Toviewdetailsaboutthelocation,holdthemousecursoroverthegreencoloredbullets.