Command Reference Guide

To add files other than the collected files to the package, copy the files to one
of the following directories before running the command:
dlc/client/getinfo, dlc/client/log, or dlc/client/tmp (on UNIX),
or .\dlc\client\getinfo, .\dlc\client\log, or .\dlc\client\tmp
(on Windows). You cannot add directories, but only files. If the files are not
copied to one of the specified directories, the package cannot be unpacked
during the unpack phase.
-unpack [filename]
Creates the dlc directory in the current directory, and unpacks the contents of
the filename to the dlc directory. If the filename is not specified, the
dlc.pck file in the current directory is unpacked.
Use this option when the collected (compressed or uncompressed) data was
packed on the Cell Manager either using the -pack option or the -localpack
option.
-uncompress filename
Uncompresses the unpacked compressed single file in the current directory.
Use this option after the packed data is unpacked using the -unpack option.
NOTES
The command can only be used on Cell Managers.
It cannot be used to collect the Application Recovery Manager installation execution
traces.
The Application Recovery Manager GUI debug files for systems other than Cell
Manager can only be gathered using the -hosts option.
To collect debug files in a cluster, the command must be run using the -hosts option;
the cluster nodes hostnames must be specified as the argument for the option. In a
cluster, if the -hosts option is not specified, the data is collected from the active
node.
EXAMPLES
1. To collect and compress all debug, log and getinfo files from the cell, and pack
them in the “dlc.pck” file in the current directory on Cell Manager, using the
verbose output, run:
omnidlc -no_filter -verbose
Command line interface reference 123