Command Reference Guide

Prepares the EVA disk group pairs configuration file for editing by reading the
contents of the file from the SMISDB and saving it under filename.
-dgrules -check EVA_name DG_name
Provides the information on the disk group that is in pair with the disk group
identified by the EVA_name and DG_name. The command returns the information
on the 1st disk group name, 2nd disk group name, and EVA name.
If there is no rule for the specified disk group, the first and the second disk groups
are the same.
-show -session SessionID
Lists expanded details of a session (identified by the backup session ID). The
output of the command is the information on all target volumes created in the
specified backup session. The following is displayed:
- Name, ID, and WWN of the target volume created in the backup session
- Name and ID of the EVA storage system on which the target volume was created
- Type of the target volume created
- ID of the source volume used in the backup session
- The backup session ID
- Time stamp of the target volume
- IR flag
- Name of the backup specification used in the backup session
- Names of the application and backup systems involved in the backup session
- If the session is excluded from use
- After instant recovery, if the source volumes (originals) are retained.
Note that you will get the same output if you run the omnidbsmis -session
SessionID command without the -show parameter.
-show -datalist DatalistName
Lists all replicas that are part of the replica set, which is identified by the backup
specification name. Replicas displayed are identified by their backup session
IDs. Note that you will get the same output if you run the omnidbsmis
-datalist DatalistName command without the -show parameter.
-list -session [—ir] [-excluded] [–original]
Lists all replicas that are part of a replica set, together with the backup session
IDs and the backup specification names. Note that you will get the same output
if you run the omnidbsmis -session command without the -list parameter.
If used together with the -ir option, the command lists the sessions marked for
instant recovery.
Command line interface reference 55