Cisco Nexus B22 Fabric Extender for HP Getting Started Guide

ManualsBrandsHP ManualsComputer AccessoriesCisco B22HP Fabric Extender with 16 FET for BladeSystem c-Class

Configuring the Cisco Nexus B22 Fabric Extender for HP

06/22/2011 22:09:48.198227: Deleting route to FEX

06/22/2011 22:09:48.203294: Module disconnected

06/22/2011 22:09:48.204160: Offlining Module

06/22/2011 22:09:48.204977: Module Offline Sequence

06/22/2011 22:09:48.527385: Module Offline

06/22/2011 22:10:23.644325: Module register received

06/22/2011 22:10:23.645444: Registration response sent

06/22/2011 22:10:23.864695: Module Online Sequence

06/22/2011 22:10:25.289316: Module Online

This example shows how to display the Fabric Extender interfaces pinned to a specific switch interface:

switch(config-fex)# show interface ethernet 1/19 fex-intf

'Fabric FEX

Interface Interfaces

---------------------------------------------------

Eth1/19 Eth100/1/4 Eth100/1/3 Eth100/1/2 Eth100/1/1

This example shows how to display the switch interfaces that are connected to a Fabric Extender uplink:

switch(config-fex)# show interface fex-fabric

Fabric Fabric Fex FEX

Fex Port Port State Uplink Model Serial

---------------------------------------------------------------

100 Eth1/19 Active 1 N2K-B22HP-P FOC1514256S

100 Eth1/20 Active 2 N2K-B22HP-P FOC1514256S

100 Eth1/21 Active 3 N2K-B22HP-P FOC1514256S

100 Eth1/22 Active 4 N2K-B22HP-P FOC1514256S

switch(config-fex)#

Note The above example shows a Fabric Extender with four uplink connections, only one of which is currently

active.

This example shows how to display the SFP+ transceiver and diagnostic optical monitoring (DOM)

information for Fabric Extender uplinks:

switch# show interface ethernet 1/40 transceiver

Ethernet1/40

sfp is present

name is CISCO-EXCELIGHT

part number is SPP5101SR-C1

revision is A

serial number is ECL120901AV

nominal bitrate is 10300 MBits/sec

Link length supported for 50/125mm fiber is 82 m(s)

Link length supported for 62.5/125mm fiber is 26 m(s)

cisco id is --

cisco extended id number is 4

switch# show interface ethernet 1/40 transceiver fex-fabric