Cisco Nexus B22 Fabric Extender for HP Getting Started Guide

Verifying the Configuration

Part Revision :

Mfg Deviation :

H/W Version : 0.0

Mfg Bits : 0

Engineer Use : 0

snmpOID : 0.0.0.0.0.0.0.0

Power Consump : 0

RMA Code : 0-0-0-0

CLEI Code :

VID : V00

Supervisor Module specific block:

Block Signature : 0x0

Block Version : 0

Block Length : 0

Block Checksum : 0x0

Feature Bits : 0x0

HW Changes Bits : 0x0

Card Index : 0

MAC Addresses : 00-00-00-00-00-00

Number of MACs : 0

Number of EPLD : 0

Port Type-Num : 0-0

Sensor #1 : 0,0

Sensor #2 : 0,0

Sensor #3 : 0,0

Sensor #4 : 0,0

Sensor #5 : 0,0

Sensor #6 : 0,0

Sensor #7 : 0,0

Sensor #8 : 0,0

Max Connector Power: 0

Cooling Requirement: 0

Ambient Temperature: 0

switch(config-fex)#

Verifying the Configuration

The Onboard Administrator (OA) is the management module used to support and manage the HP

BladeSystem c-Class enclosure or the HP Integrity Superdome 2 and all the devices used in the

enclosure. Once the switch is installed in the interconnect bay, the OA verifies that the switch type

matches the mezzanine cards present on the server blades. If there is no mismatch, the OA powers on the

switch. If the switch does not power on, check the enclosure and switch status using the OA web

interface. For more information and troubleshooting tips, see the HP BladeSystem Onboard

Administrator User Guide or the or the HP Integrity Superdome 2 Onboard Administrator User Guide.

To verify the configuration,

1. Locate the LEDs. See Figure 6.