Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Important Notes

Cisco IOS Notes

These notes apply to Cisco IOS software:

• If the switch requests information from the Cisco Secure Access Control Server (ACS) and the

message exchange times out because the server does not respond, a message similar to this appears:

00:02:57: %RADIUS-4-RADIUS_DEAD: RADIUS server 172.20.246.206:1645,1646 is not

responding.

If this message appears, make sure that there is network connectivity between the switch and the

ACS. You should also make sure that the switch has been properly configured as an AAA client on

the ACS.

• If the switch has interfaces with automatic QoS for voice over IP (VoIP) configured and you upgrade

the switch software to Cisco IOS Release 12.2(40)EX1 or later, when you enter the auto qos voip

cisco-phone interface configuration command on another interface, you might see this message:

AutoQoS Error: ciscophone input service policy was not properly applied

policy map AutoQoS-Police-CiscoPhone not configured

If this happens, enter the no auto qos voip cisco-phone interface command on all interfaces with

this configuration to delete it. Then enter the auto qos voip cisco-phone command on each of these

interfaces to reapply the configuration.

Device Manager Notes

These notes apply to the device manager:

• You cannot create and manage switch clusters through the device manager. To create and manage

switch clusters, use the CLI or Cisco Network Assistant.

• We recommend this browser setting to reduce the time needed to display the device manager from

Microsoft Internet Explorer.

From Microsoft Internet Explorer:

1. Choose Tools > Internet Options.

2. Click Settings in the “Temporary Internet files” area.

3. From the Settings window, choose Automatically.

4. Click OK.

5. Click OK to exit the Internet Options window.

• The HTTP server interface must be enabled to display the device manager. By default, the HTTP

server is enabled on the switch. Use the show running-config privileged EXEC command to see if

the HTTP server is enabled or disabled.