Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Open Caveats

• CSCsy85676

When you configure an ACL and enter the access-group interface configuration command to apply

it to an interface for web authentication, the output from the show epm session ip-address or show

ip access_list interface interface-id privileged EXEC command does not show any web

authentication filter ID.

There is no workaround.

• CSCsz18634

On a switch running Cisco IOS release 12.2(46)SE, the output of the show interfaces privileged

EXEC command shows 0 packets for port channel input and output rates.

The workaround is to reload the switch by entering the reload privileged EXEC command.

• CSCtb08823

SNMP requests on the stpxRSTPPortRoleTable object only return information for the stack master.

There is no workaround.

• CSCtb25230

When a switch stack is configured with DHCP snooping enabled on the host VLAN, hosts connected

to the stack master receive bootp packets, but the a packet might not be forwarded to the end hosts

connected to stack member switches. The behavior depends on which interface in the stack received

the packet.

The workaround is to disable DHCP snooping for the affected VLAN.

• CSCtb88425

If you press the MODE button to enter Express Setup setup mode after the switch has received an

IP address dynamically through DHCP, HTTP authentication with the default username and

password cisco/cisco fails.

Use one of these workarounds:

–

Downgrade the image to 12.2(46)SE where there is no HTTP authentication.

–

Use the console to perform initial configuration.

• CSCtc02635

On switches running Cisco IOS release 12.2(50)SE3 running MAC authentication bypass with

multidomain authentication (MDA, IP phones connected to a port might not be able to regain

network connectivity in the VOICE domain if the session times out and all RADIUS servers are

unreachable.

There is no workaround.

Resolved Caveats

• CSCsi52914

When you are configuring a SPAN session, this message might erroneously appear even when two

source sessions are not configured:

% Platform can support a maximum of 2 source sessions

The workaround is to reboot the switch stack.