Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Documentation Updates

• CSCta53893

If the host is in multiple-authentication (multiauth) mode and you configure the fallback

authentication process as IEEE 802.1x or MAc authentication bypass, the per-user ACL does not

work when the port uses web authentication as the fallback method and then uses 802.1x or MAC

authentication bypass as the fallback method.

The workaround is to restart the switch.

• CSCta57846

The switch unexpectedly reloads when copying a configuration file from a remote server or from

flash memory containing logging file flash:

The workaround is to enter the logging file flash:filename global configuration command to

configure logging to flash instead of copying to flash.

• CSCta78502

When you have configured a login banner by entering the banner login c message c global

configuration command and the switch reloads, the output of banner is missing a carriage return,

making the format incorrect.

There is no workaround.

• CSCta80514

When you enable MAC address learning on a VLAN and then change the interface configuration

(such as adding the VLAN to the list of VLANs allowed on a trunk), MAC address learning is not

disabled on the interface. If you disable MAC address learning on the switch, high CPU utilization

occurs when the local forwarding manager tries to ut does not learn MAC addresses.

There is no workaround.

• CSCtb77378

When you use IEEE 802.1x authentication with web authentication and an HTTP page opens, the

switch redirects the user to an HTTP login page, not a HTTPS login page.

The workaround is to remove the custom banner.

• CSCtb84303

In a switch stack, when the SNMP vlan change (vmMembershipEntry) MIB is sent to a member

switch other than the stack master, line protocol and notification flapping occurs.

There is no workaround.

• CSCtb97439

When remote neighbors change, the LLDP MIB does not properly update the remote neighbors.

The workaround is to clear the LLDP table by entering the clear lldp table privileged EXEC

command.

Documentation Updates

• Updates to the Software Documentation, page 26

• Updates to the Switch Getting Started Guide, page 27

• Updates for the System Message Guide, page 28