Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Documentation Updates

Updates for the System Message Guide

These messages were added:

Error Message DOT1X-5-FAIL: Authentication failed for client ([chars]) on Interface

[chars] AuditSessionID [chars]

Explanation

The authentication was unsuccessful. The first [chars] is the client ID, the second

[chars] is the interface, and the third [chars] is the session ID.

Recommended Action No action is required.

Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the 802.1X

action. AuditSessionID [chars]

Explanation

The system memory is not sufficient to perform the IEEE 802.1x authentication. [chars]

is the session ID.

Recommended Action Reduce other system activity to reduce memory demands.

Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on

Interface [chars] AuditSessionID [chars]

Explanation

Authentication was successful. The first [chars] is the client ID, the second [chars] is

the interface, and the third [chars] is the session ID.

Recommended Action No action is required.

Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on

[chars] AuditSessionID [chars]

Explanation

The client MAC address could not be added to the MAC address table because the

hardware memory is full or the address is a secure address on another port. This message might

appear if IEEE 802.1x is enabled. [enet] is the client MAC address, the first [chars] is the interface,

and the second [chars] is the session ID.

Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.

If the client address is on another port, remove it from that port.

Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary

VLAN [dec] to 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign a primary VLAN to an IEEE 802.1x port, which is not

allowed. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.

Recommended Action Use a different VLAN.