Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Documentation Updates

Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid

secondary VLAN [dec] to PVLAN host 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign a nonsecondary VLAN to a private VLAN host

IEEE 802.1x port. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the

session ID.

Recommended Action Change the mode of the port so that it is no longer a PVLAN host port or use

a valid secondary VLAN.

Error Message DOT1X_SWITCH-5-ERR_PRIMARY_VLAN_NOT_FOUND: Attempt to assign VLAN

[dec], whose primary VLAN does not exist or is shutdown, to 802.1x port [chars]

AuditSessionID [chars]

Explanation

An attempt was made to assign a private VLAN whose primary VLAN does not exist or

is shut down. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.

Recommended Action Make sure the primary VLAN exists and is not shut down. Verify that the

private VLAN is associated with a primary VLAN.

Error Message DOT1X_SWITCH-5-ERR_SEC_VLAN_INVALID: Attempt to assign secondary VLAN

[dec] to non-PVLAN host 802.1x port [chars] AuditSessionID [chars]

Explanation

An attempt was made to assign a secondary VLAN to a port that is not a private VLAN

host port, which is not allowed. [dec] is the VLAN, the first [chars] is the port, and the second [chars]

is the session ID.

Recommended Action Change the mode of the port so that it is configured as a private VLAN host

port, or use a different VLAN that is not configured as a secondary VLAN.

Error Message DOT1X_SWITCH-5-ERR_SPAN_DST_PORT: Attempt to assign VLAN [dec] to

802.1x port [chars], which is configured as a SPAN destination AuditSessionID

[chars]

Explanation

An attempt was made to assign a VLAN to an IEEE 802.1x port that is configured as a

Switched Port Analyzer (SPAN) destination port. [dec] is the VLAN, the first [chars] is the port, and

the second [chars] is the session ID.

Recommended Action Change the SPAN configuration so that the port is no longer a SPAN

destination port, or change the configuration so that no VLAN is assigned.

Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_MDA_INACTIVE: Multi-Domain Authentication

cannot activate because Data and Voice VLANs are the same on port AuditSessionID

[chars]

Explanation

Multi-Domain Authentication (MDA) host mode cannot start if the configured data

VLAN on a port is the same as the voice VLAN. [chars] is the port session ID.

Recommended Action Change either the voice VLAN or the access VLAN on the interface so that

they are not the same. MDA then starts.