Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Documentation Updates

Error Message DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on

Interface [chars]

Explanation

Authentication was successful. [chars] is the interface.

Recommended Action No action is required.

Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on

[chars]

Explanation

The client MAC address could not be added to the MAC address table because the

hardware memory is full or the address is a secure address on another port. This message might

appear if IEEE 802.1x is enabled. [enet] is the client MAC address, and [chars] is the interface.

Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.

If the client address is on another port, remove it from that port.

Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary

VLAN [dec] to 802.1x port [chars]

Explanation

An attempt was made to assign a primary VLAN to an IEEE 802.1x port, which is not

allowed. [dec] is the VLAN, and [chars] is the port.

Recommended Action Use a different VLAN.

Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid

secondary VLAN [dec] to PVLAN host 802.1x port [chars]

Explanation

An attempt was made to assign a nonsecondary VLAN to a private VLAN host IEEE

802.1x port. [dec] is the VLAN, and [chars] is the port.

Recommended Action Change the mode of the port so that it is no longer a private VLAN host port,

or use a valid secondary VLAN.

Error Message DOT1X_SWITCH-5-ERR_PRIMARY_VLAN_NOT_FOUND: Attempt to assign VLAN

[dec], whose primary VLAN does not exist or is shutdown, to 802.1x port [chars]

Explanation

An attempt was made to assign a private VLAN whose primary VLAN does not exist or

is shut down. [dec] is the VLAN, and [chars] is the port.

Recommended Action Make sure the primary VLAN exists and is not shut down. Verify that the

private VLAN is associated with a primary VLAN.

Error Message DOT1X_SWITCH-5-ERR_SEC_VLAN_INVALID: Attempt to assign secondary VLAN

[dec] to non-PVLAN host 802.1x port [chars]

Explanation

An attempt was made to assign a secondary VLAN to a port that is not a private VLAN

host port, which is not allowed. [dec] is the VLAN, and [chars] is the port.

Recommended Action Change the mode of the port so that it is configured as a private VLAN host

port, or use a different VLAN that is not configured as a secondary VLAN.