Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(52)SE

OL-19714-01

Installation Notes

The /reload option reloads the system after downloading the image unless the configuration has been

changed and not saved.

For //location, specify the IP address of the TFTP server.

For /directory/image-name.tar, specify the directory (optional) and the image to download. Directory

and image names are case sensitive.

This example shows how to download an image from a TFTP server at 198.30.20.19 and to overwrite

the image on the switch:

Switch# archive download-sw /overwrite

tftp://198.30.20.19/cbs31x0-universal-tar.122-40.EX1.tar

You can also download the image file from the TFTP server to the switch and keep the current image by

replacing the /overwrite option with the /leave-old-sw option.

Recovering from a Software Failure

For additional recovery procedures, see the “Troubleshooting” chapter in the software configuration

guide for this release.

Installation Notes

You can assign IP information to your switch by using these methods:

• The Express Setup program, as described in the switch getting started guide.

• The CLI-based setup program, as described in the switch hardware installation guide.

• The DHCP-based autoconfiguration, as described in the switch software configuration guide.

• Manually assigning an IP address, as described in the switch software configuration guide.

New Features

These sections describe the new supported hardware and the new and updated software features provided

in this release:

• “New Hardware Features” section on page 7

• “New Software Features” section on page 8

New Hardware Features

For a list of all supported hardware, see the “Hardware Supported” section on page 2.