Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem User Guide (AA-RWEBA-TE, September 2007)

Cisco MDS 9124e Fabric Switch for HP c-Class BladeSystem 21

Checking LEDs

See Figure 6 to locate power-on LEDs.

Figure 6 Verifying power-on LEDs

Verify that the LEDs match the indicators described in Table 7.

Table 7 Power-on LEDs

Setting the IP address

Obtain the following items to set the IP address via a serial connection:

• Computer with a terminal application (such as HyperTerminal in a Windows environment or

TERM in a UNIX environment

• Null modem serial cable

Set the IP address:

1. Verify that the enclosure is powered on.

2. Identify the active OA in the BladeSystem.

3. Connect a Null modem serial cable from your computer to the serial port of the active OA.

4. Configure the terminal application as follows:

• In a Windows environment:

• Baud rate—9600 bits per second

• 8 data bits

• None (No parity)

•1 stop bit

•No flow control

Item Description

Indicators

UID LED

- used to help user locate a specific

module in the BladeSystem for replacement,

etc.

Off

2 Health ID LED Steady green light

EXT 1 EXT 2 EXT 3 EXT 4

181738