- HP Color Laser-Jet Printer User Manual

NOTE: You can also view the IP address in the EWS or HP ToolboxFX by selecting the Advanced
Network Settings tab.
IPv4 and IPv6 settings
Only the IPv4 protocol can be configured manually. The IPv4 protocol can be set from HP ToolboxFX
or from the product control panel. The IPv6 protocol can be selected only from the product control panel.
Link speed setting
NOTE: Incorrect changes to the link speed setting might prevent the product from communicating with
other network devices. For most situations, the product should be left in automatic mode. Changes can
cause the product to power cycle. Changes should be made only while the product is idle.
1. On the control panel, press Setup.
2. Use the arrow buttons to select Network configuration, and then press OK.
3. Use the arrow buttons to select Link speed, and then press OK.
4. Use the arrow buttons to select one of the following settings.
●
Automatic
●
10T Full
●
10T Half
●
100TX Full
●
100TX Half
NOTE: The setting must match with the network product to which you are connecting (a network
hub, switch, gateway, router, or computer).
5. Press OK. The product will power cycle.
ENWW Configure the network product (HP LaserJet CM1312 (fax/photo-card model) only) 51