Operation Manual

1. Press the Home button on the product control panel.
2. To enable manual configuration, open the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPV6 Settings
●
Address
●
Manual Settings
●
Enable
Select the On option, and then touch the Save button.
3. To configure the address, touch the Address button and then touch the field to open a keypad.
4. Use the keypad to enter the address, and then touch the OK button.
5. Touch the Save button, or press the OK button.
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the product in automatic mode. Incorrect changes to the link speed and duplex settings
might prevent the product from communicating with other network devices. To make changes, use the
product control panel.
NOTE: The product setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only
when the product is idle.
1. Press the Home button on the product control panel.
2. Open the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
Link Speed
3. Select one of the following options:
68 Chapter 5 Manage the product ENWW