HP J1473A 4-port, J1474A 8-port, J1475A Console Switch Rackmount Owner's Manual

www.hp.com/racksolutions

Basic Operations

System Control &

Maintenance

Key Sequence Action

<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss of

mouse signal. Use this command to restore the signal if you are

using a server with a standard PS/2 mouse driver.

<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a loss of mouse

signal. Use this command to restore the signal if you are using a server

with a Microsoft IntelliMouse or other wheel mouse driver.

<CM>AV<Enter> Displays the current ﬁ rmware version of your switch.

<CM>SG<Enter> Enables the scan Go command (By address only)

<CM>SH<Enter> Enables the scan Halt command

<CM>M+<Enter> Enables mouse suspension of scanning

<CM>M-<Enter> Disables mouse suspension of scanning

<CM>H1<Enter> Changes the hot-key sequence to the default: (NumLock, -)

<CM>H2<Enter> Changes the hot-key sequence to the 1st alternate: (NumLock, *)

<CM>H3<Enter> Changes the hot-key sequence to the 2nd alternate: (CTRL, ~)

<CM>OSD0<Enter> Disables the OSD Sequence

<CM>OSD1<Enter> Changes the OSD sequence to the default: (CTRL, CTRL)

<CM>OSD2<Enter> Changes the OSD sequence to the 1st alternate: (Alt, Alt)

<CM>OSD3<Enter> Changes the OSD sequence to the 2nd alternate: (Shift, Shift)

<CM>ZM<Enter> Use this command to resynchronize the mouse after a device

or server hot-plug. Repeat, if necessary, until synchronization is

re-established.

Note: Using this command while the mouse is operating cor-

rectly will cause the mouse to lose sync.

The following commands are used for system control and maintenance. Enter the

command sequences to perform the actions described in the table below.