User manual
VCCI (klasse B)-samsvarserklæring for brukere i Japan
Merknad om strømledning for brukere i Japan
Erklæring om støynivå for Tyskland
Visuell visning av erklæring om arbeidsplass for Tyskland
Merknad til brukere av telefonnettverket i USA: FCC-krav
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the rear
(or bottom) of this equipment is a label that contains, among other information, a product identier in the
format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
Applicable connector jack Universal Service Order Codes ("USOC") for the Equipment is: RJ-11C.
A telephone cord, plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. HP
recommends a compliant plug, jack and 2-wire telephone cord to connect this product to the premises wiring
and telephone network. See installation instructions for details.
The REN is used to determine the quantity of devices, which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In
most, but not all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of
devices that may be connected to the line, as determined by the total RENs, contact the telephone company
to determine the maximum REN for the calling area. For products approved after July 23, 2001, the REN for
this product is part of the product identier that has the format US-AAAEQ##TXXXX. The digits represented
by ##are the REN without a decimal point (e.g., 01 is a REN of 0.1).
If this equipment causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. If advance notice is not practical, the telephone
150 Tillegg A Teknisk informasjon NOWW