Operation Manual

Connect your printer to a wireless network with a router
TIP: To print Wireless Quick Start Guide, press and hold the Information button ( ) for three seconds.
Connect your printer to a wireless network using Wi-Fi Protected Setup (WPS)
Connect your printer to a wireless network using HP printer software
Connect your printer to a wireless network using Wi-Fi Protected Setup (WPS)
Before you can connect your printer to a wireless network using WPS, make sure you have following:
A wireless 802.11b/g/n network that includes a WPS-enabled wireless router or access point.
NOTE: The printer only supports connections using 2.4GHz.
A computer connected to the wireless network that you intend to connect the printer to. Be sure you
have installed the HP printer software on the computer.
If you have a WPS router with a WPS push button, follow the Push Button method. If you are not certain your
router has a push button, follow the PIN method.
To use the Push Button Conguration (PBC) method
1.
Press and hold the Wireless button ( ) on the printer for more than three seconds to start WPS push
mode. The Wireless light starts blinking.
2. Press the WPS button on your router.
NOTE: The product begins a timer for approximately two minutes while a wireless connection is established.
If the printer connects successfully, the blue Wireless light stops blinking and remains on.
To use the PIN method
1.
Press the Wireless button ( ) and Information button ( ) at the same time to print the network
conguration page, and then locate a WPS PIN.
2.
Press and hold the Wireless button ( ) from the printer control panel for more than three seconds.
The wireless light starts blinking.
3. Open the conguration utility or software for the wireless router or wireless access point, and then enter
the WPS PIN.
62 Chapter 7 Connect your printer ENWW