Administration Manual

Field
Description
Basics
Program nam e
Leave the default value: rissminer
Command line
Leave the default value. Note that the -k command line switch a nd
the name of the mining rule is picked up in th e command.
Server to run on
Thedefaultisthecurrentmailserver. Ifyouneedtochangethe
server, click the arrow and select another server.
This is the only field in the B asics column that you should edit.
Comments
Leave the default value.
Schedule
Enabled/disabled
Click the arrow and select Enabled to enable the program
document.
Run at times
Enter a time peri od to run the program.
The time period and repeat interval depend on the type of a rchive
job you are running.
• For selective archiving, you might want to run the program once
a day, with the time set to a specific hour. When you use a
specific hour, the repeat interval must be set to 0.
• For journaling, run the program throughout the day. Enter a time
period of 12:00 AM–11:59 PM, with a brief repeat interval (not
less than 10 minutes).
Repeat interval
Enter the time between mining sessions, in minutes. You will need
toexperimenttoseehowlongtheminingprocesstakes. Thetime
depends on the number of mailboxes, the size of the messages, and
the speed of the server.
The repeat interval should never be less than 10 minutes.
If you entered a specific hour in the Run at times field, set this field
to 0.
Days of week
Click the arrow and select the check box in front of each day the
job runs.
For journaling, be sure to select each day of the week.
Click OK when you are finished.
4. (Optional) Click the Administration tab and complete the settings.
Fie
ld
Desc
ription
Owners
Cli
ck the a rrow and select any additional owners of the mining task.
Administrators
Cli
ck the arrow and select any additional administrators of the
min
ing task.
Last updated
Do n
ot edit — information only.
70
Configuring selective archiving