User's Manual

Note:
1. When the battery is drained dry and the satellite synchronization is off , the user must reset the
date/time before the function -automatic record is started. If the user doesn't reset the
date/time, the device will give you alert after one minutes and the automatic record will be
started .
2. But if the satellite synchronized ,the device can do automatic record immediately.
2.5.3 Setting the Universal Time Code (UTC)
Depending on your location, you may need to change the current UTC
setting of the camcorder so that the correct date and time are updated
when a GPS signal is detected.
1. If recording is in progress, press the button to stop recording.
2. Press the button to open the OSD menu.
3. Use the or buttons to navigate to the Satellite
Synchronization option and press the OK button. Ensure that the
On setting is selected and press the OK button again to view the
UTC setting.
4. Refer to the UTC Map below and use the or
button to select the desired setting and press the OK button to
confirm the setting.
5. Press the button to exit the menu.