Hitachi Dynamic Link Manager Software Users Guide for Windows (6.6) (HIT5201-96005, April 2011)

3. Creating an HDLM Environment
102
always selected. To select an EMC DMX series or EMC CX series LU as the
HDLM management-target device, select EMC Symmetrix DMX Series,
CLARiiON CX Series. To select an HP EVA series LU as the HDLM
management-target device, select HP StorageWorks EVA Series.
14. Follow the instructions shown in the messages that appear in the window.
• If a dialog box with the following text appears during installation, and the
Storport Miniport driver is being used as the HBA driver, stop the HDLM
installation. After that, install QFE838894 or a later version of the Microsoft
Storport driver, or install Windows Server 2003 SP1 or later.
Notes on using a Storport Miniport driver
Read these notes before using a Storport Miniport driver as an HBA
driver.
The file version of the Storport.sys of this system (Microsoft(R) Storport
driver) is n.n.nnnn.n.
When using a Storport Miniport driver as an HBA driver:
Please update the Storport Miniport driver to a Storport.sys with a file
version n.n.nnnn.n or later.
• The PRSV key will be registered before the installation finishes. If the
KAPL09131-W message appears, follow the procedure described in step 15.
• Although a message prompting you to restart the host appears after the
installation has finished, a restart is not necessary.
• In the last installation window, the following message might be output:
When you manage a host by using Global Link Manager and
Windows firewall is enabled on that host, execute the
firewall_setup command to allow a firewall exception.
If Global Link Manager will not be used to manage HDLM, you do not need
to take any action.
To manage HDLM with Global Link Manager, register Firewall exceptions.
For details, see 3.5.8 Firewall Settings for Managing HDLM by Using
Global Link Manager.
15. Check the results of the installation.
If you have performed an unattended installation, check the installation results
from the command prompt.
16. After the installation finishes, execute the
dlmprsvkey utility with the -v
parameter specified.
Execute the following command: