Hitachi Dynamic Link Manager Software Users Guide for Windows (6.6) (HIT5201-96005, April 2011)

3. Creating an HDLM Environment
115
down.
3. Restart each host.
Start them in a single-path configuration.
4. Log on to Windows as a member of the Administrators group.
5. Save the license key file directly under the Windows installation-destination
drive. Also, instead of using the license key, you can directly specify the license
key during the installation of HDLM.
installation-drive
:\hdlm_license
The license key file will be deleted after the installation finishes.
6. Perform the installation.
• If you are not performing an unattended installation, insert the DVD into the
drive and run the installation program
setup.exe.
The program checks whether HDLM has already been installed. If HDLM
5.4 or earlier has been installed, the KAPL09129-E message will appear. If
this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been
installed, the KAPL09173-W message will appear. If this happens, carry out
the procedure shown in 3.5.5 Upgrade Installation or Re-installation of
HDLM. If no message appears, go to step 7.
• If you are planning to perform an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted
:\HDLM_Windows\DLMTo
ols\installhdlm -f
installation-information-settings-file
Specify
n for the restart key in the installation-information settings file.
This command checks whether HDLM has already been installed. If HDLM
5.4 or earlier has been installed, the KAPL09129-E message will appear. If
this happens, carry out the procedure shown in 3.5.6 Migrating from HDLM
5.4 or Earlier to HDLM 5.5 or Later. If HDLM 5.5 or later has been
installed, the KAPL09183-E message will appear, and then the upgrade
installation or re-installation will be performed.
After the installation is complete, go to step 14.
7. The program checks the MPIO driver version, and then installs the MPIO driver.