Hitachi Dynamic Link Manager Software Users Guide for Windows (6.6) (HIT5201-96005, April 2011)

3. Creating an HDLM Environment
154
3.8 Setting Up Integrated Traces
When HDLM is used, the dlnkmgr command and GUI operation logs are output to
the integrated trace information files of Hitachi Network Objectplaza Trace Library
(HNTRLib2) (installation-destination-drive
:\Program
Files
#
\HITACHI\HNTRLib2\spool\Hntr2n.log files (n indicates a file
number)).
#
For Windows Server 2003 (excluding the x86 edition) or Windows Server 2008
(excluding the x86 edition),
Program Files is Program Files (x86).
If a lot of integrated trace information is output, the older information might end up
getting deleted in a very short amount of time. Also, if a large amount of integrated
trace information is suddenly all output at the same time, any integrated trace
information that is overflowing the buffer might not be saved into the integrated trace
files. To save as much information as possible, change the settings for Hitachi Network
Objectplaza Trace Library, increasing the integrated trace file size and buffer size.
Note that if the values are too large, it will place a heavy load on the system. When
determining these values, be sure to consider these operational tradeoffs.
Table 3-20: Default and Recommended Values for the Integrated Trace File Settings
shows the default and recommended values for the integrated trace file settings.
Table 3-20: Default and Recommended Values for the Integrated Trace File
Settings
If Hitachi Network Objectplaza Trace Library (HNTRLib2) is already installed, the
existing settings will be inherited. If you change these settings, keep in mind that
programs other than HDLM also use them. If an earlier Hitachi Network Objectplaza
Trace Library (HNTRLib) is already installed, the settings will not be inherited.
Setting Default value Recommended value
Integrated trace file size 256 (KB) 4096 (KB)
Number of integrated trace files 4 8
Buffer size per
monitoring interval
Monitoring cycle 10 (seconds) 5 (seconds)
Buffer size per
monitoring interval
64 (KB) 256 (KB)
Number of messages
to be output per
monitoring interval
Monitoring cycle 0 (seconds) 0 (seconds)
Number of messages to be
output
00