HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

210 Chapter 6 GUI Reference
From the pull-down list box, select the desired trace output level. In the event of an
error, you may need to set the trace level to 1 or higher and collect the log information
again.
– 0: Do not output any trace
– 1: Error information only
– 2: Summary of program operation
– 3: Details of program operation
– 4: All information
The amount of log information to be output increases as the value of the setting
increases. As the amount of log information to be output increases, the amount of time
before log information wraps around and existing information is overwritten becomes
shorter.
A trace file in which a trace level can be set is hdlmtrn.log (n indicates a file number
from 1 to 64). If the HDLM version on the host is earlier than 5.6, a trace level can be
set in hntr2n.log or hntrn.log (n indicates a file number from 1 to 16).
File size (for Error log)
In this box, you set the size of the error log file (in kilobytes). Set a value between 100
and 2000000. You can set the file size for the HDLM manager log (dlmmgrn.log (n
indicates a file number from 1 to 16)) and the HDLM GUI log (dlmguin.log (n indicates
a file number of 1 or 2)). The specifiable range for the file size of the HDLM GUI log is
100 to 9900. If you set a value of 9901 or more, 9900 is applied. The specified value is
applied to the HDLM manager log, however, if the version of HDLM is a version earlier
than 5.6, you must specify a value from 100 to 9900.
When all log files reach the specified size, the oldest error log file is overwritten by new
log information.
You can collect an error log of up to 32000000KB (approximately 30GB) by specifying the
log file size and the number of log files.
Number of files (for Error log
)
In this box, you set the number of log files. Set a value from 2 to 16.
By specifying the log file size and the number of log files in combination, you can collect
up to 32000000KB (approximately 30GB) of error logs in total.
You can set the number of files for only the HDLM manager log (dlmmgrn.log (n
indicates a file number from 1 to 16)). The number of files for the HDLM GUI log
(dlmguin.log (n indicates a file number of 1 or 2)) is fixed at 2.
When the HDLM version on the host is earlier than 5.6, this box is disabled and you
cannot set the number of log files.
File size (for Trace)
In this box, you set the size of the trace (in kilobytes). Set a value from 100 to 16000.