HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

HiCommand
®
Dynamic Link Manager (HDLM) for Windows
®
Systems User’s Guide 295
Message ID Message Details and Actions
KAPL01019-W The target path was not found. Operation name
=
aa...aa
Details
aa...aa: offline, online, view
 offline/online operation
The specified path does not exist.
 view operation
The paths have not been configured because
creation of the HDLM environment or
configuration changes to the HDLM operating
environment have not finished.
Action
 offline/online operation
Use the
view operation of the HDLM command
(
dlnkmgr) to check the specification, and then
retry. For details on the
view operation, see
section
7.7.
 view operation
Refer to
Chapter 3. or section 4.6, and then
configure the path. If the same error occurs
again, execute the DLMgetras utility for
collecting HDLM error information, acquire the
error information, and then contact your HDLM
vendor or the company with which you have a
service contract. For details on the
DLMgetras
utility, see section
8.2.
KAPL01021-E Cannot execute the HDLM command due to
insufficient memory.
Details
Memory required for HDLM command
processing could not be allocated.
Action
Terminate unnecessary applications to increase
the amount of free memory, and then try again.
KAPL01023-W The last Online path for the device cannot be
placed Offline(C).
Details
The path specified in the
offline operation
cannot be placed Offline(C) because it is the
last path of the LU.
Action
Use the
view operation of the HDLM command
(
dlnkmgr) to check the status of the path. For
details on the
view operation, see section 7.7.
KAPL01024-W The specified parameters cannot be specified at
the same time. Operation name =
aa...aa,
parameters =
bb...bb
Details
aa...aa: offline, online, set, view
bb...bb
: Parameters cannot be specified at
the same time
Action
Execute
help operation-name of the HDLM
command (
dlnkmgr) to check the parameter
that can be specified, and then retry. For details
on the help operation, see section 7.3.