Hitachi Dynamic Link Manager Software Users Guide for AIX (6.6) (T5208-96010, April 2011)

3. Creating an HDLM Environment
102
12. For a re-installation, execute the following command:
• When installing HDLM from the DVD-ROM
# /directory-in-which-the-DVD-ROM-is-mounted/installux.sh
or
# installp -aXFd /directory-in-which-the-DVD-ROM-is-mounted/
HDLM_AIX all
• When installing HDLM from the directory to which the DVD-ROM was
copied
# /directory-copied-from-DVD-ROM/installux.sh
or
# installp -aXFd /directory-copied-from-DVD-ROM/HDLM_AIX all
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
If you execute the
dlmrmdev utility without the -e parameter specified at step 3
or 7 and then the
KAPL09048-E message is displayed, the hdisk for the device
that is managed by HDLM still remains.
If you execute the
dlmrmdev utility with the -e parameter specified at step 3 or
7 and then the
KAPL09048-E message is displayed, the hdisk for the device that
is managed by HDLM still remains, and its status is
Available. Re-execute the
procedure in step 3.
During installation, the
KAPL09241-W message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
13. Execute the following command to make sure that the package is installed.
# lslpp -la DLManager.mpio.rte
Make sure that the fileset item in the output listing contains
DLManager.mpio.rte, and all the displayed statuses are COMMITTED.
If one or more of the displayed statuses are
BROKEN, uninstall and then re-install
HDLM.
14. Execute the following command to make sure that the hdisk.
# cfgmgr