Hitachi Dynamic Link Manager Software Users Guide for AIX (6.6) (T5208-96010, April 2011)

3. Creating an HDLM Environment
120
Because HDLM version 5.9 or later requires deletion of hdisk, do not attempt to
perform device configuration (
cfgmgr command) before performing step 17.
16. Perform a new installation of HDLM version 5.9 or later.
Perform steps 4 to 9 of (1) When Installing HDLM in a Local Boot Disk
Environment in 3.5.3 Performing a New Installation of HDLM. Note that you do
not have to perform steps 2 to 3.
17. Execute the
dlmmigsts utility to restore the HDLM environment settings
information and the HDLM execution environment ODM settings that you saved
in step 14.
# /cdrom/HDLM_AIX/hdlmtool/dlmmigsts -r -odm /tmp/
any-desired-directory/odm-environment-settings-file-name -set /tmp/
any-desired-directory/set-environment-settings-file-name
For details about the dlmmigsts utility, see 7.6 dlmmigsts Utility for Assisting
HDLM Migration.
18. Execute the following command to reconfigure the device:
# cfgmgr
19. Make sure that the HDLM settings information has been properly inherited.
• Make sure that the HDLM environment settings information has been
properly inherited.
Execute the following command, and then compare the current HDLM
environment settings information with the settings information saved in step
13:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
• Make sure that the HDLM execution environment ODM settings
information has been properly inherited.
Execute the following command, and then compare the current HDLM
execution environment ODM settings information with the settings
information saved in step 13:
# /usr/DynamicLinkManager/bin/dlmodmset -o
If the HDLM settings information has been properly inherited, skip to step 21.
20. If the HDLM settings information has not been properly inherited, execute the
following command: