Hitachi Dynamic Link Manager Software Users Guide for AIX (6.6) (T5208-96010, April 2011)

6. Command Reference
259
Legend:
AFB: Automatic failback
IEM: Intermittent error monitoring
#1
When this condition is not satisfied, the KAPL01080-W message is output and an
error occurs. The status of intermittent error monitoring does not change.
Set IEM to on. • When a path is being monitored (during a period
of conditional intermittent error monitoring), the
value of the error count and the elapsed
monitoring time are reset to
0, and then
intermittent error monitoring will restart.
• When a path is not being monitored, nothing
changes.
Change the IEM settings. • While a path is being monitored, the value of the
error count and the elapsed monitoring time are
reset to 0, and then intermittent error monitoring
will restart.
#1
• When a path is not being monitored, the IEM
settings will take effect again when the path is
recovered from the error status by performing an
automatic failback.
Set IEM to
off. • IEM is disabled.
• The error count, elapsed monitoring time, and
information about paths not subject to automatic
failbacks are cleared.
off Set AFB to on. The operations of AFB and IEM do not change.
Change the AFB setting. AFB operates using new settings.
Set AFB to
off. AFB is disabled.
Set IEM to
on.
IEM is enabled.
#1
off
on
#2
Set AFB to on.
AFB and IEM are enabled.
#1
Set AFB to off. The operations of AFB and IEM do not change.
off Set AFB to on. AFB is enabled.
Set AFB to
off. The operations of AFB and IEM do not change.
Setting Available operation Result of operation
AFB IEM