Hitachi Dynamic Link Manager Software Users Guide for AIX (6.6) (T5208-96010, April 2011)

6. Command Reference
274
Example 6
The following example shows how to display information about the audit log
settings:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -
Audit Log Facility : -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time =
yyyy/mm/dd hh:mm:ss
#
(2) To Display Path Information
When displaying path information, if you specify either the
-item or -c parameter
and also specify the
-path parameter, you can select the items to display and display
a summary of path information. This section describes each parameter, path
information and displayed items.
Parameters to display path information:
-path
When you specify the -path parameter and do not specify either the -c or -item
parameter, the information will be displayed about the HDLM managed paths
without abbreviating or selecting items.
In the sub-parameters (following
-path), you can filter the paths to be listed
using
-hdev and sort the list using -srt. When you omit both parameters, the
command displays information for all the paths in order of increasing
AutoPATH_IDs.
For details on what is displayed in each item, see Table 6-12: Displayed Path
Information.
AutoPATH_IDs displayed by the
-path parameter depend on the sequence in
which HDLM detects the paths after when a host is started up. Because of this,
make sure that you use the path name
PathName to identify a path.
The sub-parameters are as follows:
-hdev host-device-name
Displays information only for the paths accessing the specified host device.
Specify hdisk name for host-device-name.
The host-device-name string is case -sensitive.
-stname