HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

HiCommand
®
Dynamic Link Manager (HDLM) for Windows
®
Systems User’s Guide 97
13. Follow the instructions shown in the messages that appear in the window.
– If a dialog box that begins with the following sentence appears during installation,
and the Storport Miniport driver is used as the HBA driver, stop the HDLM
installation. Then, install QFE838894 or a later version of the Microsoft Storport
driver, or install Windows Server 2003 SP1.
Notes on using a Storport Miniport driver:
Read these notes before using a Storport Miniport driver as an HBA driver.
The file version of the Storport.sys of this system (Microsoft(R) Storport driver) is
n.n.nnnn.n.
When using a Storport Miniport driver as an HBA driver:
Please update the Storport Miniport driver to a Storport.sys with a file version
n.n.nnnn.n or later.
– The PRSV key is registered before the installation finishes. If the KAPL09131-W
message appears, follow the procedure described in step 15.
14. Check the results of the installation.
If you performed an unattended installation, check the installation results in the
command prompt.
15. When the installation finishes, execute the dlmprsvkey utility with the -v parameter
specified. Make sure that the PRSV key displayed by the dlmprsvkey utility is unique
among those of any other hosts in the SAN. If the PRSV key is not unique or is not
registered, or if the KAPL09131-W message appears, execute the dlmprsvkey utility
with the -r parameter specified to re-register the PRSV key. If the PRSV key is not
registered, the HDLM functions may not operate normally. For details about the utility,
see section
8.4.
If you are using the license key file, it will be deleted when the installation finishes. The
KAPL09115-W message appears if deletion of this file fails. In this case, delete the file
manually, such as by using Explorer.
16. Shut down the host. Leave the host in a single-path configuration until you check (in
step 25) whether HDLM has been successfully installed.
17. On all the hosts comprising the cluster system, perform the operations from step 1 to
step 16.
18. Confirm that all the hosts making up the cluster system have been shut down.
19. Modify the settings in the storage system according to the procedure described in the
hardware notes provided with HDLM.
20. Start the host individually.
21. Log on to the Windows system again as a member of the administrators group.