Manualshelf

HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

ManualsBrandsHP ManualsSoftwareHitachi HDLM for IBM AIX Media Kit
141142143144145146147148149150
HiCommand
®
Dynamic Link Manager (HDLM) for Windows
®
Systems User’s Guide 125
4.1.4 Using the EMC DMX series, EMC CX Series, and HP EVA series
Only HDLM version 5.7 or later can manage the EMC DMX series or EMC CX series. For HDLM
versions earlier than 5.7, see section
3.6.4 and then perform an update installation.
Only HDLM version 5.9.1 or later can manage the HP EVA series. For HDLM versions earlier
than 5.9.1, see section
3.6.4 and then perform an update installation.
You can display and operate the HDLM GUI windows for the Thunder 9200/9500V series,
Lightning 9900/9900V series TagmaStore, and Universal Storage Platform V. If you specify
the EMC DMX series, EMC CX series, or HP EVA series as an HDLM management-target device,
use HDLM commands to display information and set the operating environment. For details
about each command, see
Chapter 7.
When using EMC CX Series, connect only one port of the storage to the switch in a single-
path configuration and connect the switch to the server in a multi-path configuration.
4.1.5 Notes on Using Veritas Backup Exec for Windows and the Veritas NetBackup Intelligent
Disaster Recovery Facility
When you use Veritas Backup Exec for Windows and the Veritas NetBackup Intelligent
Disaster Recovery facility, the following might occur:
If all paths experience a failure and Windows recognizes some or all paths, the disk
numbers might have changed from those that were in effect when the host started up. In
that case, restarting the host restores the original disk numbers. Restore the original
disk numbers, and then use Veritas Backup Exec for Windows or the Veritas NetBackup
Intelligent Disaster Recovery facility.
Restoring the Windows 2000 Server system requires that the host be restarted twice.
If you restore Windows Server 2003, the STOP:c0000135 error message appears and the
system stops. In that case, restart the host. If restoration of Windows Management
Instrumentation information fails, the HDLM performance monitor can no longer be used.
In that case, re-install HDLM.