HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

208 Chapter 6 GUI Reference
 The error count, elapsed monitoring time, and
information about paths not subject to automatic
failback are completely cleared.
OFF Set AFB to ON. The operations of AFB and IEM do not change.
Change the AFB setting. AFB operates using new settings.
Set AFB to OFF. AFB is disabled.
Set IEM to ON. IEM is enabled.
#2
OFF ON
#3
Set AFB to ON. AFB and IEM are enabled.
#2
Set AFB to OFF. The operations of AFB and IEM do not change.
OFF Set AFB to ON. AFB is enabled.
Set AFB to OFF. The operations of AFB and IEM do not change.
Legend:
AFB: Automatic failback
IEM: Intermittent error monitoring
#1
If you want to change automatic failback settings but you do not want to reset the
intermittent error monitoring settings, use the HDLM commands.
#2
When the conditions for settings values of the automatic failback check interval and the
intermittent error monitoring are not satisfied, the KAPL02064-W error occurs. In this
case, the intermittent error monitoring status does not change.
#3
Since automatic failback is OFF, intermittent error monitoring is disabled, and the
settings for intermittent error monitoring are not specifiable.
When the HDLM version on the connected host is earlier than 5.4, intermittent error
monitoring is not supported. So, the intermittent error monitoring setting is disabled and
not selectable.
Reservation level
You cannot set the reservation level (the reservation control method for the LU).
Remove LU
When using the Remove LU functionality, set it to ON. When not using the Remove LU
functionality, set it to OFF.
For details on the LU deletion functionality, see section
4.6.2. For details on the LU
deletion function value, see
Table 6.13.