HiCommand Dynamic Link Manager (HDLM) for Windows Systems User's Guide (HIT5201-96001, January 2008)

234 Chapter 7 Command Reference
Table 7.6 lists the license key types.
Table 7.6 License Key Types
Type Description
Permanent license key Permanent licenses are valid for using HDLM in an ongoing basis.
Temporary license key
*
The temporary license key is used temporarily, for example, when a user performs product
evaluations. Temporary licenses are valid for only 120 days after installation. You cannot
reuse a temporary license key.
Emergency license key The emergency license key is used temporarily, for example, when issuing a permanent
license key that is delayed for some reasons. Emergency licenses are valid for 30 days after
they are entered. You cannot reuse an emergency license key.
A temporary license key cannot be installed by using the dlnkmgr set operation.
The following example shows how to update the license key (when the license key file
exists):
>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation name = set [y/n]: y
KAPL01071-I A permanent license was installed.
KAPL01001-I The HDLM command completed normally. Operation name = set, completion
time = yyyy
/mm/dd hh:mm:ss
>
The following example shows how to update the license key (when the license key file does
not exist).
>dlnkmgr set -lic
KAPL01049-I Would you like to execute the operation? Operation name = set [y/n]: y
KAPL01083-I There is no license key file. File name =
Windows-installation-destination-
drive-name
\hdlm_license
KAPL01068-I Enter a license key:
*************
KAPL01071-I A permanent license was installed.
KAPL01001-I The HDLM command completed normally. Operation name = set, completion
time = yyyy
/mm/dd hh:mm:ss
>
To enable or disable the LU dynamic deletion functionality, use -rmlu { on [ -force ]
| off }.
 on: Enabled
 off: Disabled (the default)
The explanation for the following sub-parameter describes how to specify the LU dynamic
deletion functionality.
To remove an LU from HDLM management, use –force. The LU is removed from HDLM
management when all the paths to the LU are disconnected, even when an Offline(C) path is
included. For details on the LU dynamic deletion functionality, see section
4.6.2.