Quick Configuration Guide for A7000 1xT1 or 1xT1 + DSX-1 Modules 2005-04

6 www.procurve.com 5991-2115

Scenario 2: Dynamic Routing via RIP

1. At the (config)# prompt, enter router rip to activate the RIP configuration mode. Your prompt

should now display (config-rip)#.

2. Enter version 2 to globally define RIP version 2 on all interfaces.

3. Specify the networks:

Corporate HQ Router

(config-rip)#network 10.10.10.0 255.255.255.0

(config-rip)#network 192.168.72.0 255.255.255.252

Branch Office Router

(config-rip)#network 10.10.20.0 255.255.255.0

(config-rip)#network 192.168.72.0 255.255.255.252

4. Enter exit to return to the Global Configuration mode.

1. Verify that the prompt of your unit displays (config)#.

2. Enter enable password word

to set the Enable Security mode password.

3. Enter enable password md5 word

to encrypt the enable password using MD5 encryption.

The following steps show how to access the Telnet configuration parameters and change the

password. For this example, replace the underlined word

with a password of your choosing. The

ProCurve Secure Router supports five Telnet sessions (0 through 4).

1. Verify that the prompt of your unit displays (config)#.

2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session. Your

prompt should now display (config-telnet-0-4)#.

3. Enter password word

to change the login password for the Telnet session.

4. Enter exit to return to the Global Configuration mode.

Set Enable Security Mode Password

Note

The Enable Security mode passwords are case sensitive.

Configure Telnet Access

Note

An enable security mode password and the Ethernet port parameters must be

defined before configured Telnet sessions are activated. Refer to Configure the

Ethernet Port Parameters on page 2 and Set Enable Security Mode Password on

page 6 for more information.