PoE/PoE+ Planning and Implementation Guide 2011-09

1-8
Introduction
PoE Capabilities of the HP Products
The dual-personality ports have either auto-sensing 10/100/1000Base-T
RJ-45 or mini-GBIC connectivity. The dual-personality ports do not support
PoE.
HP ProCurve 2610 Switches
These switches support some pre-standard PoE devices. For a list of these
devices, see the FAQs for your switch model. This feature must be enabled; it
is not a default feature.
The 2610-48-PWR (J9089A), has 48 Integrated PoE auto-sensing
10/100Base-TX RJ-45 ports with four Gigabit Uplink ports.
The 2610-24-PWR (J9087A), has 24 Integrated PoE auto-sensing 10/100Base-
TX RJ-45 ports with four Gigabit Uplink ports.
The 2610-24/12PWR (J9086A), has 12 Integrated PoE auto-sensing 10/100Base-
TX RJ-45 ports with four Gigabit Uplink ports.
For more information, refer to the Management and Configuration Guide
for your switch at www.hp.com/networking/support.
PoE
Power
Fault
Dual-Personality Port:
10/100/1000-T (T) or Mini-GBIC (M)
(Port 9T is IEEE Auto MDI/MDIX)
Status
Reset
Clear
Console
PoE-Integrated 10/100-TX Ports (1 - 8)  (Ports are HP Auto-MDIX)
ProCurve
Switch 2600-PWR
J8762A
*
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
Link
Mode
LED
Mode
Spd
Act
FDx
Test
EPS
Fan
2
3
4
Link Mode
1
Link
Mode
5
6
7
8
9T
Link
Mode
PoE
*
9M
!
Use only one (T or M) for Port 9
RPS