CM Professional Series Color Printer - (English) Network Guide

4. The HP 2500CM Professional Series Color Printer comes with an

internal MIO JetDirect Print Server preinstalled. However, if you have

purchased the HP 2500C Professional Series Printer, you may

purchase the internal JetDirect Print Server.

For the list of HP MIO JetDirect Print Servers, please refer to our

web site at www.hp.com/go/jetdirect.

4.1 Installing the HP JetDirect Print Server Card

Step 1 - Verify that the Printer Works

1. Turn on the printer.

2. Press [MENU] repeatedly until SELF TEST MENU appears.

3. Press [ITEM] repeatedly until PRINT DIAGNOSTIC PAGE appears.

4. Press [SELECT] to print the Diagnostic Page.

Step 2 - Install the HP JetDirect Print Server Card into the Printer

Note: The HP JetDirect card contains electronic components that can be

damaged by static electricity through electrostatic discharge (ESD). To prevent

ESD, maintain frequent contact with any bare sheet metal surface on the

printer. A grounding wrist strap (or similar device) is useful for this purpose.

Handle the card carefully at all times. Avoid touching electronic components

or circuit paths.

1. Turn off the printer and unplug the power cord.

2. Unscrew and remove the metal plate on the left side of

the printer.

3. Insert the card. Align the card with the guide rails in the printer.

4. Press the card into the slot until the card is firmly seated.

5. Tighten each thumbscrew a little at a time, alternating

between each side until both screws are secure.

6. Connect the network cable to the card.

7. Connect the power cord and turn on the printer.

2500C/C+/CM

Installing the Print Server

JETDIRECT

10/100 Base-Tx

(RJ-45)

10/100 Base-Tx

(RJ-45)

JETDIRECT

10/100 Base-Tx

(RJ-45)

10/100 Base-Tx

(RJ-45)