HP 2500C/C+/CM Professional Series Color Printer - (English) User's Guide
Table Of Contents
- Contents
- Printer Basics
- Step 1 - Unpack the Printer
- Step 2 - Remove All Tapes from the Printer
- Step 3 - Connect Cables
- Step 4 - Set LCD Language Preference
- Step 5 - Install Ink Cartridges
- Step 6 - Install Printheads
- Step 7 - Load Paper in Tray 2
- Step 8 - Load Paper in Tray 3
- Step 9 - Align Printheads
- Step 10 - Install the Printer Software
- Basic Printing Tasks
- Maintaining the Printer
- Installing the PostScript Module
- Installing Additional Memory
- LCD Messages
- Troubleshooting
- Understanding the Diagnostic Test
- Customer Support
- HP Supplies and Accessories
- Printer Specifications
- Minimum Printing Margins
- Hewlett-Packard Limited Warranty Statement
- Declaration of Conformity
- Regulatory Notices
1
22
8. When you have finished entering the values press [Select].
9. The printer will print a confirmation page consisting of 2 squares and a cross.
10. Check the confirmation page to see if the lines on the squares and the
cross are aligned.
11. Re-align the printheads if the confirmation page is not satisfactory.
Calibrate Color
If the color tints of your documents have shifted towards yellow, magenta
or blue, run the “Calibrate Color” utility to balance the color tints. It is not
advisable to calibrate color unless the shifts in color tints are visible.
To run the “Calibrate Color” utility:
1. Double-click on the HP 2500C Toolbox icon on your computer
desktop.
2. Click on Maintenance tab.
3. Click on Calibrate Color and follow the instructions on the screen.
The HP 2500CM Color Printer comes with the PostScript 3 module
pre-installed. The HP 2500C/C+ Color Printer can be upgraded to a
PostScript printer by installing the HP 2500C PostScript Upgrade Kit.
See Supplies and Accessories.
PostScript Printing Memory Requirements
The HP 2500C Color Printer has 4 MB* of memory installed. After you
install the PostScript Module, you will get an additional 8MB of memory.
1. Put on the anti-static wrist strap and clip the other end to a grounded
metal piece.
Note: Failure to do so may damage the printer or the memory module.
*The HP 2500C+ has 12MB memory installed. For Europe only, the HP 2500C
comes standard with 12MB RAM.
2500C/C+/CM
HP
Installing the PostScript Module