HP 2500C/C+/CM Professional Series Color Printer - (English) User's Guide
Table Of Contents
- Contents
- Printer Basics
- Step 1 - Unpack the Printer
- Step 2 - Remove All Tapes from the Printer
- Step 3 - Connect Cables
- Step 4 - Set LCD Language Preference
- Step 5 - Install Ink Cartridges
- Step 6 - Install Printheads
- Step 7 - Load Paper in Tray 2
- Step 8 - Load Paper in Tray 3
- Step 9 - Align Printheads
- Step 10 - Install the Printer Software
- Basic Printing Tasks
- Maintaining the Printer
- Installing the PostScript Module
- Installing Additional Memory
- LCD Messages
- Troubleshooting
- Understanding the Diagnostic Test
- Customer Support
- HP Supplies and Accessories
- Printer Specifications
- Minimum Printing Margins
- Hewlett-Packard Limited Warranty Statement
- Declaration of Conformity
- Regulatory Notices
11
10
9
8
7. Push in the PostScript 3 Module until the two clips snap into place.
8. Lift the plastic flap, place the metal panel on the Rear Access Door
and fasten the screws.
9. Reconnect all cables to the back of the printer and power ON the
printer.
10. To verify installation of the PostScript 3 Module, select the PostScript
Firmware Version option in the Information Menu from the key panel.
11. The installed PostScript Firmware Version is displayed on
the LCD panel.
24
7
PS FW VER
X.X.X