HP 2500C/C+/CM Professional Series Color Printer - (English) User's Guide
Table Of Contents
- Contents
- Printer Basics
- Step 1 - Unpack the Printer
- Step 2 - Remove All Tapes from the Printer
- Step 3 - Connect Cables
- Step 4 - Set LCD Language Preference
- Step 5 - Install Ink Cartridges
- Step 6 - Install Printheads
- Step 7 - Load Paper in Tray 2
- Step 8 - Load Paper in Tray 3
- Step 9 - Align Printheads
- Step 10 - Install the Printer Software
- Basic Printing Tasks
- Maintaining the Printer
- Installing the PostScript Module
- Installing Additional Memory
- LCD Messages
- Troubleshooting
- Understanding the Diagnostic Test
- Customer Support
- HP Supplies and Accessories
- Printer Specifications
- Minimum Printing Margins
- Hewlett-Packard Limited Warranty Statement
- Declaration of Conformity
- Regulatory Notices
3
2
1
7
If your printer has the PostScript module installed, you may install up to
64 MB of additional memory.
See Supplies and Accessories
To do so:
1. Put on the anti-static wrist strap and clip the other end to a grounded
metal piece.
Note: Failure to do so may damage the printer or the memory module.
2. Switch off your printer and remove all cables from the back of the
printer.
3. Lift up the two rear door latches to open the Rear Access Door.
25
2500C/C+/CM
HP
Installing Additional Memory
2500C/CM
Professional Series Color Printer
HP
PostScript CD
12. Install the PostScript 3 software from the accompanying CD. Refer to
the back of the CD jacket for installation instructions.